User Guide

3 Wiring Instructions
3
QR600 series: 11 core wire connection mark
Red Black White
Green Gray
Pink Yellow
Orange
Blue Light Blue Light Green
VCC GND
WD1
WD0
/ / / / /
485A
485B
Please connect the device to other equipment according to the wiring definition of the QR code
reader. In addition, the following only refers to the partial wiring of the QR code reader and the
controller. It does not represent all wiring definitions of the controller. Please refer to the actual
controller wiring definition.
2 Product Introduction
3.1 Wiring Definition
3.2 Device Connection
The QR600 series QR code reader is a new generation of intelligent access control card reader
developed by our company. The product has high-end appearance, high scanning speed, high
recognition rate, strong compatibility, and can be connected to any access control controller
that supports Wiegand input. The reader adapts to various application scenarios and supports
the identification of RFID radio frequency cards and QR codes, and uses non-contact
identification to replace traditional RFID cards. Dynamic QR codes can better protect user
information security, and the product supports IP65 waterproof, which can be applied in
community management, visitor management, hotel management, unmanned supermarkets,
and other fields. The design of this series of products is also in line with CE, FCC and other
certification standards.
The features of QR600 QR code reader are as follows:
New QR code access control technology
ID supports EM4100/EM4200
IC supports identification of MF, Desfire EV1, resident ID card and QR code
Su p p o r t QR co d e re c o gn i t i on: 2 D : QR , D a ta M a t r i x, P D F 417 ; 1 D : GS 1 d at a b a r,
code128/Ean128, UPC/EAN, Codebar, code39/code93
Support Wiegand34/26/32/66/RS485 switching at the same time
Support OSDP
Number keyboard (optional)