User Guide

10
4.5 Reader Parameter Setting
On the "Read Card Setting" page, set the reading parameters of the card reader.
Operation Steps:
1.
Director y ID
The ID of the directory file where the content of the user card to be read is located.
File ID
The file ID where the content of the user card to be read is located.
Key ID
The key ID of the external authentication of the CPU card.
The key of the CPU user card content to be read.
Note: The authentication key of the user card must be consistent with the "User Card
Key" set on the configuration card.
CPU Card Key
Start Block
The content of the user card to be read starts from the first few blocks.
Start Byte
The content of the user card to be read starts from the first few bytes.
MF Card Key
The sector key of the MF user card content to be read.
Prior Choice
When setting the card reader to swipe the composite card, select CPU priority or MF
card priority.
Read Card Mode
Custom settings read the physical card number or content of the CPU card, the
physical card number or content of the MF.
NFC Switch
NFC function can be enabled or disabled.
Parameter
Description
Write Configuration
Read Configuration
After modifying the above parameters, click ”Write configuration”, that is, the new
configuration information is successfully written to the card reader.
Customised settings to read CPU card physical card number or content, MF physical
card number or content, ID card physical card number or content, ISO15693 physical
card number or content.