Installation Guide

Remove the turnstile and use a electric drill to drill holes according to the marks.

①

Clean up the fragments and dust after drilling, then place the turnstile on the installation site again.

Check whether the drilled holes corresponds to the mark on the turnstile.

Note: Before inserting the bolt, the user must pull the power cable and Ethernet from the machines and put them

into the wire slot.

Align the device with the drilled holes. Then, insert the bolts accordingly and ﬁx them with a wrench.

Finally, insert the washer and nut, tighten it with a wrench.

②

Bolt Nut Washer

①

②