Installation Guide

320.00mm
950.00mm
3 Preparation
2
To install the mTS1000 you must have:
A Screwdriver: To remove or install the screw on the device.
A Pencil: To mark the device size and the screw hole.
A Electric Drill: To drill holes in accordance to the marked screw holes.
A Wrench: To secure the M12 expansion screw on the device.
4 Installation
1. Place the turnstile to the installation site.
A Tapeline: To measure the dimensions that need to be measured during the installation of the device.
A Hex Wrench: To remove or install the screw on the device.
Note: Except for the hex wrench, all other tools should be prepared on your own.