Installation Guide mTS1000 Series Tripod Turnstile Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
1 Installation Requirements 1. It is recommended that the tripod turnstile must be installed on a horizontal solid platform with a height of 50mm to 100mm. 2. It is also recommended that the tripod turnstile should not be used in the corrosive environment. 3. Make sure the ground wire of the system is reliably connected to avoid personal injuries or other accidents. 4.
Preparation To install the mTS1000 you must have: A Screwdriver: To remove or install the screw on the device. A Pencil: To mark the device size and the screw hole. A Electric Drill: To drill holes in accordance to the marked screw holes. A Wrench: To secure the M12 expansion screw on the device. A Tapeline: To measure the dimensions that need to be measured during the installation of the device. A Hex Wrench: To remove or install the screw on the device.
2. Use the key to open the chassis of the turnstile and remove the chassis cover. ① ② 3. Mark on the turnstile with a pencil according to the holes. 150.00mm 250.
4. Remove the turnstile and use a electric drill to drill holes according to the marks. ① ② 5. Clean up the fragments and dust after drilling, then place the turnstile on the installation site again. Check whether the drilled holes corresponds to the mark on the turnstile. 6. Align the device with the drilled holes. Then, insert the bolts accordingly and fix them with a wrench. Finally, insert the washer and nut, tighten it with a wrench.
7. Use the key to open the top lid of the turnstile. ② ① 8. Align the arm assembly with the assembly inside the chassis, and then secure it with screws.
9. After assembling the arm, the resistance of the arm can be adjusted by rotating the damper left and right. Rotate the damper and observe the number on the damper. The greater the number it is, the larger the resistance will be. Damper 10. Connect the online cables and perform the power-on test. If it passes the test, install the chassis cover. 100.
11. Install the chassis cover and close the top lid, then lock it with the key.
12. We suggest marking a warning line on the floor to remind the user when installation complete. It reminds user to wait outside the warning line until the previous user complete the verification and leave the turnstile.
9
ZKTeco Industrial Park, No. 32, Industrial Road, Tangxia Town, Dongguan, China. Phone : +86 769 - 82109991 Fax : +86 755 - 89602394 www.zkteco.
