User's Manual
Table Of Contents
4-inch Visible Light Terminal
User Manual
Page | 77 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Software side
Login to ZKBioAccess software, click System > Communication > Communication Monitor to set the
ADMS service port, as shown in the figure below:
Add Device on the Software 15.2
Add the device by searching. The process is as follows:
1） Click Access Control > Device > Search Device, to open the Search interface in the software.
2） Click Search, and it will prompt [Searching……].
3） After searching, the list and total number of access controllers will be displayed.
4） Click [Add] in operation column, a new window will pop-up. Select Icon type, Area, and Add to
Level from each dropdown and click [OK] to add the device.