Installation Instruction LH6500 Version: 1.0 Date: Jun.
Before Installation N Lock Diagram O R P A E B F G C I J D L M H K 1 Q
Packing List H A J L C M N T O B S F E G 2 I D
Door Preparation 1. Check door thickness; prepare proper screws and spindles. Door Thickness D Spindles G Spindle I Screws 40 - 50 mm 30 mm 75 mm 25 mm Note: If the door is thicker than 40-50 mm, this lock shall not be applicable. 2. Check the door’s open direction.
Cautions 1. New lock is defined as always open mode until it is locked once by mifare card. 2. Please swipe authorised card, time sync card, room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place. 4. To power on the lock, four alkaline AA batteries (not included) are required. Non-alkaline and rechargeable batteries ARE NOT RECOMMENDED. 5.
Installation 1. Drill holes on the door 2. Remove the mortise latch plate (J) door thickness 40~50 mm center line of the handle K desired handle height H backset 62.5 mm J Note 1: Align the template along the vertical center line of the mortise (H) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling.
3.
4. Install lock cylinder (C) E 5.Install spindle (D) and stud (B) F C D E E F B A B C C D Note: Ensure the two triangles are in horizontal alignment.
7.Install spindle (G) and (D) 6.
9.Install the battery (P) and battery cover (Q) 8.
10.
11. Test Lock by mechanical key (S) Step1: Remove the cover on the key hole with a hook ( T ). Step2: Insert mechanical key (S) into the key hole and rotate it at 90°.
FCC warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
ZK Building, Wuhe Road, Gangtou, Bantian, Buji Town, Longgang District, Shenzhen China 518129 Tel: +86 755-89602345 Fax: +86 755-89602394 www.zkteco.com © Copyright 2018. ZKTECO CO., LTD. ZKTeco Logo is a registered trademark of ZKTeco or a related company. All other product and company names mentioned are used for identification purposes only and may be the trademarks of their respective owners. All specifications are subject to change without notice. All rights reserved.
