Installation Guide FR1500S Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
Installation Dimensions(mm) 38.0 7.1 121.3 77.3 Note: Not all the devices have the fingerprint cover. The real product prevails.
Installation STEP 2 Take out the front panel as shown below Method 1: Mounting on the standard Single gang junction box Lay the cables from the desired hole in Single gang junction box and fix the machine part to the box part. The Single gang junction box's size recommendations: Location column: 83.3mm Inside of the box Depth: Minimum 36mm Outside the box size: maximum length 120mm , maximum width 76mm m 83.
Method 2: Mounting inside the wall STEP 1 Place the mounting sticker to the place where device needs to be installed STEP 2 Drill fixing holes and dig mounting groove deep of 36mm wall Fixing Hole The depth of the installation groove is 36mm 36m Instruction for the Mounting Paper Before the device is fastened, please stick the paper to the place where you want to install it, then make holes and lay cables according to the mounting paper.
