Daim Ntawv Qhia Tus Neeg Siv

4
Mark the installation position of the rear hanging plate and the outlet position of the
network cable and power cable in parallel using a level ruler (the distance between the
device edge and the rear hanging plate fixing hole, the green mark in the figure is the rear
hanging plate fixing hole and the outlet position of the network cable and power cable,
unit: mm).
2.
30
8236
52
46
16
Drill holes at the wall marking point using a 6mm impact drill, then dig a hole between the
four hole positions (for network cable and power cable routing).
3.
Insert 6mm expansion rubber plugs into the mounting holes.
4.