User`s manual

Installation and Network Configuration
15
2. Connect the power supply of the device.
3. During normal connection, if it is a 10M network, the orange lamp is always
on; if it is a 100M network, the green lamp is also on. The physical connection
with network is completed after the lamp shining.
4. In the “Start” menu, select “Programs”--“Accessories”--“Command Prompt”,
and input the ping command to the device address (e.g.: type in “ping
192.168.1.88”). If “Request timed out” does not pop up, the device is
successfully connected to network.
 Notice: 1) The default IP address is “192.168.1.88” and the default HTTP
port is 80. If needed to change IP address or port, refer to Network Setting in
WEB Server User Manual.
2) If the device is in a network section different from computer, refer
to How to Visit IPC on Internet in WEB Server User Manual for the
connection during different network sections.
 .............................. Connect to Wireless Network
Before starting the wireless network, connect the IPC to network by Ethernet cable,
visit the device through browser, enter “Network Setting” interface, and set the
wireless network connection following the operating procedure, as detailed in
Network Setting in WEB Server User Manual.