User manual

201 Circle Drive N, Suite 116 Piscataway, NJ 08854 Tel: [phone] Fax: [phone]
www.zkaccess.com
Upon Door Status Monitoring, if the number of doors on the current interface ≤64, the system will, by default, show the doors in
pictures to monitor door statuses. Once the number exceeds 64, the system will automatically list the doors.
When putting the cursor on a door, it will show relevant parameters and operations: device, door number, door name, remote
opening, and remote closing. Icons in different colors represent statuses as follows:
Icon
Status
Door
alarming
Door
closed
when
online
Door
opened
when
online
Door
sensor
unset
Device
banned
Door
Offline
Door
opening
timeout
Personnel Photo Display:
If there is a person of concern in the Real-time Monitoring and the corresponding photo is set prior, the photo will be displayed
in Real-time Monitor. And the event name, trigger time, person name will be displayed on the photo.
Event Monitoring:
The system automatically acquires monitored device event records, including normal access control events and exceptional
access control events (including alarm events). Alarm events appear in red. Exceptional events excluding alarm events appear
in orange. Normal events appear in green.
Presently, when an alarm event record appears on the event monitoring interface, the “Find alarm event” prompt will appear
on the upper right corner. After the user clicks the link, the system will redirect to the alarm event monitoring interface by
opening a new window (or tab page).
On the current event monitoring interface, the recent records are on the top, enabling the user to see without dragging the
scrollbar. Currently, the interface shows up to 50 records.
Click [Find Alarm Event] on the upper right corner to access the [Alarm Event] interface and the user will see alarm events
monitored in [Event Monitoring] before page turn and alarm events after the current time point.
2. Alarm Event:
Alarm Event records are actually part of Exception records, namely, Alarm Event records in Exception records.
Alarm Event Monitoring only monitors alarm events acquired in the system and only monitors alarm events after the time of
accessing the interface.
The Alarm Event Monitoring list is shown below:
3. Electro-Map
Before using the Electro-Map, the user needs to add the map to the system. After successfully adding, the user can add doors,
zoom-in and zoom-out on the map (and on the door on the map), etc. If the user changes the door icon, or the map, or the
position of door icon, click [Save Position] to save the current position, then the user can view the setting at the next time it is
accessed.