Owner's Manual

T-bar ceilings
Vertical Alignment
Along with the ability to project a level reference
plane, the LaserVision® AUTO has a built-in manual vertical vial. When the laser is in its vertical
position, the vertical vial located under the window in the control panel is used to plumb the rotatable
beam of laser light. Vertical setups can be used for:
Aligning bolts and wall plates
Layout work
Plumbing walls and panels
Transferring lines from floor to ceiling
Aligning and plumbing posts and tall forms
Plumb Spot
The LaserVision® AUTO projects an auto-plumbed laser spot from the top of the rotating head that
can be used for:
A reference beam at 90° to the rotatable beam to assist with layout tasks.
A self plumbed beam for very accurately transferring points from floor to ceiling.
Circular level vial: The circular vial indicates
if the laser is rough leveled closely enough for
the automatic compensator to take over and
maintain a precise level.
1.
Leveling knobs: Use the leveling knobs to
center the bubble in the circular level vial. The
leveling knobs are also used during vertical
alignment (see Vertical And Line Layout
Setup).
Note: The leveling knobs are at 90° to the
leveling pivot point, which is directly below the
circular vial. As you face the control panel and
look down at the circular vial, the leveling knob
on your right controls bubble movement from
left to right. The leveling knob at the back
(below the battery door) controls bubble
movement from front to back. Turning the
leveling knob on your right in a clockwise motion will move the bubble to the right and turning
2.
LaserVision Auto file:///Volumes/Macintosh HD/Users/zirconcorporation/Docume...
2 of 10 10/22/12 12:10 PM