Installation Guide

Zircon Corporation
|
1580 Dell Avenue
|
Campbell, CA 95008
|
[e-mail]
|
www.zircon.com
|
408-963-4550
|
800-245-9265
MetalliScanner
®
MT X
METAL FINDING
Industrial-Grade Electronic Metal
Locator that utilizes active and inductive
technologies to minimize detection
errors related to different building
materials and construction environments
during the calibration process.
The MetalliScanner
®
MT X metal locator
is designed to find metal in standard
residential, commercial, and industrial
construction. It is calibrated to locate
rebar up to 4 in. (10 cm) deep.
Choose from two scanning modes
depending on the environment to
be scanned. Normal Scan for shallow
rebar placed in tight grid patterns and
DeepScan
®
for deeper pieces of pipe
or rebar.
Use to find or avoid rebar in concrete
before drilling.
• Large blue transflective backlit LCD
screen for easy viewing, even under
direct sunlight
• Center and Signal Strength Indication
of metal up to 4 in. (10 cm) deep
• Battery Strength Indicator continuously
displays the battery level and will
flash when the battery level is too low
for operation
• Ergonomic handle with Patented
Pivot Pinch Grip design
• Integrated marker system to
mark target location
• Pivoting handle attachment
for easier scanning included
• Water and dust resistant
©
2018. DeepScan, MetalliScanner, and Zircon are trademarks or registered trademarks of Zircon Corporation • C/N 2535 Rev C 04/18
SPECIFICATIONS
Dimensions 9.37 in. H x 5.14 in. W x 2.81 in. D
(238 mm x 131 mm x 72 mm)
Weight 1 lb. (454 g) without batteries
Battery Type 3 AA Alkaline, required
Position Accuracy*
Center of #4 (½ in. [13 mm]) rebar at a
minimum grid spacing of 6 in. (15 cm)
typically within ± ½ in. (13 mm)
Depth* Up to 4 in. (10 cm)
Operating Temperature
20° to 105°F (-7° to 41°C)
Storage Temperature
-20° to 150°F (-29° to 66°C)
Humidity 5-90%, RH (non-condensing)
Water Resistance
Splash and water resistant,
not waterproof
*NOTE: USE ONLY IN ACCORDANCE WITH MT X INSTRUCTIONS.
Sensing depth and accuracy can vary depending on scanning
environment conditions such as mineral contents, moisture,
texture and consistency of the wall materials.
Scan for Metal
ZirconTV
ZirconCorporation
ZirconTools
ZirconToolPro
ZirconTools