Installation Guide

Zircon Corporation
|
1580 Dell Avenue
|
Campbell, CA 95008
|
[e-mail]
|
www.zircon.com
|
408-963-4550
|
800-245-9265
MetalliScanner
®
MT 7
METAL FINDING
MetalliScanner
®
MT 7 metal detector quickly
and easily locates rebar, pipes, and other metal
before you saw or drill. The bright, backlit
display indicates metal target depth (inches
and centimeters) up to 6 in. deep, type of
metal located (ferrous or non-ferrous),
and whether you are moving towards or away
from a target. Use to find and avoid rebar
in concrete before drilling, to find pipes and
junction boxes behind tile, and even detect
the nails/tacks in studs behind lath and plaster
walls. This powerful tool saves time and
money by eliminating guesswork, rework,
needless holes, and costly broken drill bits
or saw blades. Recommended uses include
locating and reinforcing rebar in masonry and
measuring subsurface nail spacing in roofing
material for compliance with building codes.
• Features two scanning modes;
Standard mode DeepScan mode
• Locates and determines the depth of
1
⁄2 in. rebar and
1
⁄2 in. copper pipe up to
6 in. (15 cm) deep
• Finds and differentiates ferrous and
non-ferrous metal
• Position accuracy to within ±
1
⁄2 in. (13 mm)
for #4 rebar or
1
⁄2 in. copper pipe
• Backlit display and audio tone clearly
indicate location of target
• Pivoting handle attachment for extended
and overhead reach
• Rubberized handle and built-in lanyard loop
• Includes 9V battery and protective
carrying case
©
2017. MetalliScanner and Zircon are trademarks or registered trademarks of Zircon Corporation • C/N 2269 Rev C 03/17
SPECIFICATIONS
Dimensions 9.72 in. H x 4.29 in. W x 2.05 in. D
(247 mm x 109 mm x 52 mm)
Weight 10.3 oz. (292 g) without battery
Battery Type 9V alkaline
Position Accuracy
Center of #4 (½ in.) rebar or ½ in.
(13 mm) copper pipe at a minimum
grid spacing of 6 in. (152 mm) typically
within ½ in. (13 mm)
Depth* Up to 6 in. (152 mm) ± 1 in. (25 mm)
Operating Temperature
20° to 120°F (-7° to 49°C)
Storage Temperature
-20° to 150°F (-29° to 66°C)
Humidity 5% - 90%, non-condensing
Water Resistance
Splash resistant, not waterproof
*NOTE: Specifications subject to change. Sensing depth and accuracy
can vary due to moisture, content of materials, wall texture, paint, etc.
Scan for Metal
ZirconTV
ZirconCorporation
ZirconTools
ZirconToolPro
ZirconTools