Installation Guide

© 2020. Zircon is a registered trademark of Zircon Corporation • GF-4031 Rev A 03/20
Specifications
Dimensions Receiver: 7.09 in. L x 1.97 in. H x 1.18 in. W
(18 cm L x 5 cm H x 3 cm W)
Transmitter: 4.33 in. L x 2.36 in. H x 1.57 in. W
(11 cm L x 6 cm H x 4 cm W)
Weight Receiver: 5 oz. (142 g) with battery
Transmitter: 4.66 oz. (132 g)
Battery Type 9V alkaline, required
Working Power Range
80 – 300 V AC, 50/60 Hz +/– 1%, 4 W Max
Operating Temperature
20°F to 104°F (-7°C to 40°C)
Compliance Certifications
CAT III, UL, CSA (cUL), FCC
*NOTE: USE ONLY IN ACCORDANCE WITH
BREAKER ID PRO 300 INSTRUCTIONS.
*CAUTION: In no event may the Breaker ID Pro
Transmitter be used where the voltage across the
Transmitter exceeds 300 V AC, as this will cause
a complete failure of the device with damage
beyond repair.
1580 Dell Avenue
|
Campbell, CA 95008
|
[e-mail]
T: 800.245.9265
|
F: 408.963.4597
The Zircon
®
Breaker ID Pro 300 circuit breaker finder kit identifies single and
three-phase circuits of 50 Hz or 60 Hz between 80 – 300 V AC and with multiple
subpanels in residential, commercial, and industrial environments.
Use to:
• Scan for identification and labeling of all breakers
• Identify a breaker without trial-and-error
• Minimize accidental shutoffs to essential power gear like
medical equipment, servers, and appliances
• Isolate circuits for repair or replacement or work on specific
circuits without interrupting others
The Breaker ID Pro 300 Kit comes packaged in a case and includes a receiver, a transmitter
with a 2-prong 120 V AC plug adapter, two 1000 V AC rated alligator clips, assorted blades
for most outlets up to 300 V AC, a light socket adapter, and a 9V alkaline battery.
This tool calibrates automatically. To use, connect the transmitter to the circuit and scan
the breaker box twice with the included receiver. The first scan calibrates the device to
the circuit breakers. The second scan then identifies the target circuit breaker. A green LED
and audible signal indicate the correct breaker.
Features:
• Easy, one-person operation
• Functions over range of 80 – 300 V AC
• Complete set of transmitter accessories to enable connections
to a variety of circuits
• Compatible with aluminum and copper wiring
• Automatic sensitivity adjustment, no knobs or dials
• A green LED and audible signals indicate proper breaker
• UL Safety listed
• CAT III
Note: In a 3-phase application, one lead of the transmitter must be connected to the
neutral line and the other lead to one of three power lines. Do not exceed 300 V AC.
Breaker ID Pro 300
|
Circuit Breaker Finder
|
zircon.com
Breaker Identification
Breaker Identification