Owner`s manual

www.zipr.com Page 22
VR2 ERROR CODES
The VR2 controller is equipped with a self-diagnostics system that allows the user to identify
possible malfunctions. The table below identifies individual error codes (codes are displayed as a
rapid flashing of the controller lights). If you get one of these error codes, contact an authorized
Zip'r Provider.
Battery Corrective Maintenance
If the battery condition meter does not illuminate when you turn on the power:
 Check the harness connections. Make sure they are tight.
 Check the circuit breaker. Reset it if necessary.
 Check the battery connections.
TROUBLESHOOTING GUIDE
FLASHING
LIGHTS
DIAGNOSTIC SYMPTOM AND SOLUTION
1
The batteries need charging or there is a bad connection to the batteries. Check the
connections to the batteries. If the connections are good, try charging the batteries.
2
The left motor has a bad connection. Check the left motor connection.
3
The left motor has a short circuit to a battery connection. Contact an authorized Zip'r
Provider.
4
The right motor has a bad connection. Check the right motor connection.
5
The right motor has a short circuit to a battery connection. Contact an authorized Zip'r
Provider.
6
The Zip'r Mantis is being inhibited by the battery charger. Unplug the battery charger.
7
A joystick fault is indicated. Make sure that the joystick is in the neutral (center)
position before turning on the controller.
8
A controller system fault is indicated. Contact an authorized Zip'r Provider.
9
The parking brakes have a bad connection. Check the parking brake and motor
connections. Make sure the controller connections are secure.
10
An excessive voltage has been applied to the controller. This is usually caused by a
poor battery connection. Check the battery connections.
7 + 5 lower
A communication fault is indicated. Make sure that joystick cable is securely
connected and not damaged.
8 + 2 lower
An actuator trip is indicated. Check the actuator wiring.