Owner`s manual

www.zipr.com Page 14
ASSEMBLY STEPS
Your Zip'r Mantis may require some assembly. The steps below describe the major components
that can be assembled and disassembled.
WARNING! Do not attempt to operate your Zip'r Mantis until the power chair
is fully assembled.
1. If batteries were shipped uninstalled or separately, then first install the batteries. See “Care and
Maintenance” Figure 12 on page 21.
2. Slide seat into the power base seat post. See Figure 8 below.
3. Insert each armrest into seat frame, choose width and tighten the adjustment knobs.
4. Insert controller arm into one of the armrest frames. Tighten the setscrew knob to secure the
controller.
5. Lift armrest straight up (vertical), then route the controller cable along the inside of the armrest
frame and secure with the supplied wire-ties.
6. Plug the controller cables into the power cable base.
Figure 8
ASSEMBLY
Step 2
Step 4
Step 5
Step 6
Step 3