Manual

INPUT CHARACTERISTICS: M1G3-6930P
l VOLTAGE: 100V ~ 240VAC (WITH ± 10% TOLERANCE)
l FREQUENCY: 50Hz /60Hz(±3Hz)
l INPUT CURRENT: 16-8A MAX AT ANY LOW/HIGH INPUT VOLTAGE
l INRUSH CURRENT: 65/125A @ 115/230VAC (25℃)
l POWER FACTOR CORRECTION: 95% @ 230V, FULL LOAD
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
OUTPUT
VOLTAGE
MIN. [A] MAX. [A] LOAD LINE
RIPPLE & NOISE
MAX. [P-P]
5V 3.0 44 ± 5% ± 50mV 70mV
12V1 2.0 30 ± 6% ± 50mV 120mV
12V2 2.0 50 ± 6% ± 50mV 120mV
-5V 0.2 1.2 +5%, -10% ± 50mV 120mV
-12V 0.2 1.2 +5%, -10% ± 50mV 120mV
3.3V 2.0 44 ± 5% ± 50mV 70mV
+5VSB 0.4 3.5 +5%, -6% ± 50mV 70mV
REMARKS:
1. THE OUTPUT POWER OF 5V & 3.3V MAX: 80A
2. +12V1 AND +12V2 TOTAL OUTPUT MAX: 72A
3. +5V, +3.3V AND +12V TOTAL OUTPUT MAX: 890W
SPECIFICATION:
l TEMPERATURE RANGE: OPERATING: 0℃ --- 40℃ (90~240VAC INPUT)
STORAGE: -20℃ --- 80℃
l HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
l DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
l EFFICIENCY: 67% TYPICAL AT 115VAC FULL LOAD
l POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
l OVER POWER PROTECTION: 110% ~ 170%
OVER VOLTAGE PROTECTION: +5V à 5.7V ~ 6.5V, 3.3V à 3.9V ~ 4.7V
+12V à 13.3V ~ 14.3V
OVER CURRENT PROTECTION: 110% ~ 160%
l SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V, +5VSB
l EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
l SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
l REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE /
ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
l 3.3V / 5V REMOTE SENSING
l DIMENSION: 335 (D) x 369 (W) x 42 (H) mm