Instruction Manual

使用手冊 – 電源供應器 – 機種 HG2, HP2, GSM and PSL Ver. 2.0
- 7 -
規格書
請對照實際購買的產品型號。備註：僅 HG2 機種，在正常使用情形下，產品經 remote-off 遠端（即
以系統面板上的 I/O）關機後，仍會轉動風扇，作二次散熱，直至主要零件降溫到適宜的溫度而停
止。此為正常現象，亦是 HG2 機種之特點，可期增長零件壽命。
INPUT CHARACTERISTICS: HG2-6400P(G1)
 VOLTAGE: 90 ~ 240 VAC FULL RANGE.
 FREQUENCY: 47 ~ 63 HZ.
 INPUT CURRENT: 8.0 A (RMS) FOR 115VAC, 4.0 A (RMS) FOR 230VAC.
 INRUSH CURRENT: 65A MAX. FOR 115 VAC, 125A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT(A) REGULATION OUTPUT
OUTPUT
VOLTAGE
MIN. MAX.
LOAD LINE
RIPPLE & NOISE
MAX.[P-P]
5V
3 35 ± 5% ± 1%
50mV
12V
2 30 ± 5% ± 1%
120mV
-5V 0 0.8 ± 5% ± 1%
150mV
-12V 0 1 ± 5% ± 1%
150mV
3.3V
1 28 ± 5% ± 1%
50mV
+5VSB
0.1 2 ± 5% ± 1%
50mV
REMARK: OUTPUT CURRENT OF +5V & +3.3V COMBINED SHOULD NOT EXCEED 45A.
SPECIFICATION:
 TEMPERATURE RANGE: OPERATING -10℃ --- 45℃.
 HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE.
 DIELECTRIC WITHSTANDING VOLTAGE:
PRIMARY TO SECONDARY : 3000VAC FOR 1 MIN.
PRIMARY TO FG : 2200VAC FOR 1 MIN.
 EFFICIENCY: 70% TYPICAL.
 POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms.
 OVER LOAD PROTECTION: 130 +/- 20%.
OVER VOLTAGE PROTECTION:
+5V  5.7V ~ 6.5V, 3.3V  3.9V~ 4.3V, 12V  13.6V ~ 15V.
 SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V.
 EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B.
 SAFETY: MEET UL 60950, CSA C 22.2 NO. 60950, TUV EN-60950,
CCC GB4943-1995/GB9254-1998/GB17625.1-1998
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
 REMOTE ON / OFF CONTROL.
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE
ALL OUTPUT VOLTAGES (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUT VOLTAGES WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUT VOLTAGES WERE DISABLE
 ADVANCED THERMAL & ACOUSTICS CONTROL FEATURES..
 3.3V / 5V REMOTE SENSING.
 COOLING: ONE 80mm DC BALL BEARING FAN.
 DIMENSION: 140 (D) x150 (W) x 86 (H) mm (PS/2).