Manual

INPUT CHARACTERISTICS: AIN-3350 / 3400P
l VOLTAGE： 90∼264 VAC FULL RANGE
l FREQUENCY： 47∼63HZ
l INPUT CURRENT： 7.0 / 3.5 A FOR 115 / 230 VAC
l INRUSH CURRENT： 60A / 80A MAX. FOR 115 / 230 VAC
OUTPUT CHARACTERISTICS:
 OUTPU
T
 OUTPUT CURRENT  REGULATION  OUTPUT
 VOLTA
GE
 MIN.
[A]
 MAX.
[A]
 PEAK
. [A]
 LOAD  LINE
 RIPPLE&NOI
SE
 MAX. [P-P]
 5V  2  30 
 ±5%  ±1%
 50mV
 12V  1  28 / 32 
 ±3%  ±1%
 60mV
 5VSB  0  2    
REMARKS: TOTAL POWER NOT EXCEED 350/400W
SPECIFICATION:
l T TEMPERATURE RANGE：OPERATING 0℃∼45℃,STORAGE -20℃----- 70℃
l HOLD UP TIME：16mS MINIMUM AT FULL LOAD & 90VAC INPUT VOLTAGE
l DIELECTRIC WITHSTAND：INPUT/OUTPUT 1500 VAC FOR 1 MINUTE
l INPUT TO FRAME GROUND 1500 VAC FOR 1 MINUTE
l EFFICIENCY：65% TYPICAL，AT FULL LOAD
l POWER GOOD SIGNAL：ON DELAY 100ms TO 500ms,OFF DELAY 1ms
l OVERLOAD PROTECTION：110∼160% MAX
l OVER VOLTAGE PROTECTION：
l +5V→5.7V∼6.5V , 12V→13.3V∼15V
l OVER VOLTAGE PROTECTION：5V, 12V 130% +/-20% AT FULL LOAD
l EMI NOISE FILTER : FCC CLASS B, CISPR22 CLASS B
l SAFETY : MEET UL 1950, CSA 22.2 NO/ 950, TUV IEC 950
l HOT-SWAPPABLE / HOT-PLUGGABLE REDUNDANCY FUNCTION
l BALANCE LOAD SHARING DESIGN
l REMOTE SENSING DESGN
l ISOLATION: BUILT-IN IN THE POWER MODULE
l MEET IEC-1000-3-2 CLASS D (ACTIVE PFC)
l DIMENSION : 40.5(H) X 117 (W) X 190 (D)mm (MODULE ONLY)
l COOLING : TWO 40 mm DC FANS
l CONNECTOR: 48 PINS INDUSTRIAL CONNECTOR
l N + 1 POWER MODULE DESIGN CAN BE STACKABLE