SDS

Page 3/9
Safety Data Sheet (SDS)
OSHA HazCom Standard 29 CFR 1910.1200(g) and GHS Rev 03.
Issue date 01/04/2017 Reviewed on 01/04/2017
Trade name: Zippy Protectant
44.0
·
Advice for firefighters:
·
Protective equipment:
As in any fire, wear self-contained breathing apparatus pressure-demand (NIOSH approved or equivalent)
and full protective gear to prevent contact with skin and eyes.
6 Accidental Release Measures
·
Personal precautions, protective equipment and emergency procedures:
Not required.
·
Environmental precautions:
Dilute with plenty of water.
Do not allow to enter sewers/surface or ground water.
·
Methods and material for containment and cleaning up:
Ensure adequate ventilation.
Absorb with liquid-binding material (i.e. sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to section 13.
·
Reference to other sections:
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
·
Protective Action Criteria for Chemicals
·
PAC-1:
None of the ingredients are listed.
·
PAC-2:
None of the ingredients are listed.
·
PAC-3:
None of the ingredients are listed.
7 Handling and Storage
·
Handling
·
Precautions for safe handling:
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
·
Information about protection against explosions and fires:
No special measures required.
·
Conditions for safe storage, including any incompatibilities:
·
Storage
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Keep receptacle tightly sealed.
·
Specific end use(s):
No further relevant information available.
8 Exposure Controls/Personal Protection
·
Additional information about design of technical systems:
No further data; see section 7.
·
Control parameters:
·
Components with occupational exposure limits:
The following constituent is the only constituent of the product which has a PEL, TLV or other recommended
exposure limit.
At this time, the remaining constituent has no known exposure limits.
(Contd. on page 4)