User`s manual

Getting Started 61

cPCI-3920

4.5 RTM (cPCI-R3920) Installation

Follow the typical cPCI board installation and removal procedures

for the RTM. However, be careful when when inserting or remov-

ing RTMs to the chassis as these are shorter than front boards.

Refer to previous sections when connecting or installing peripher-

als to the RTM. Make sure that the RTMs you are installing are

compatible with the cPCI-3920 Series.

4.6 Hot Swap Procedures

The cPCI-3920 is not designed for hot swap operation. Do not

attempt to hot swap this board. However, the cPCI-3920 supports

the addition or removal of other boards whilst in a powered-up

state.

NOTE:

You must install the correct RTM to enable some functionalities

(I/O interfaces) on the rear panel. Installation of non-compati-

ble RTMs may damage the system board and/or other RTMs.