User`s manual

60 Getting Started
4.4 Installing the cPCI-3920 to the Chassis
To install the cPCI-3920 module to a CompactPCI chassis:
1. Refer to the chassis documentation before installing the
cPCI-3920.
2. Turn off the power in both chassis front and rear.
3. Assign a system slot for the board. Make sure you
assign the correct slot.
4. Remove the panel cover of the slot you have selected.
5. Remove the black plastic caps securing the mounting
screws to the front panel.
6. Align the top and bottom edges of the board with the
card guides on the chassis, then push the board until it is
completely flushed on the chassis.
7. Move the locking handle inward until it is fully-latched. A
slight resistance may be felt when inserting the board. If
the resistance is too strong, check if there are bent pins
on the backplane or if the board’s connector pins are
properly aligned with the connectors on the backplane.
8. Check if the board is seated properly on the slot. Secure
the board with mounting screws (behind the upper and
lower ejector)
9. Connect the cables and peripherals to the board, then
turn the chassis on.