User`s manual

Getting Started 43
CT-30
4.4 Switching to Remote Serial Console
The default graphics output setting of the CT-30 is the onboard
VGA. To switch from onboard graphics to Remote Serial Console
via COM1 on the RTM, perform the following steps.
1. Mount the VGA connector adapter card (ADAP-VGA) to
the CT-30 to use the onboard graphics as console (see
“VGA Analog Interface and Connector” on page 29).
2. Power on the system.
3. Press <DEL> to enter the AMIBIOS® Setup menu.
4. Configure the BIOS settings as outlined below.
5. Power off the system and remove the VGA connector
adapter card.
6. Reboot the system and use COM1 on the RTM as console.
4.5 Hot Swap Procedures
The CT-30 is not designed for hot swap operation. Do not attempt
to hot swap this board. However, the CT-30 supports the addition
or removal of other boards whilst in a powered-up state.
Menu Sub-menu Field Value
Advanced > Remote
Access Configuration
Remote Access Enabled
Serial port number COM1
Chipset On Board VGA Disabled
Exit Save Changes and Exit Select