User`s manual

42 Getting Started

4.2 Installing the USB Flash Disk

The CT-30 supports an onboard USB Flash Disk module via the

CN5 pin header. To install a USB Flash Disk, follow the procedure

below.

1. Secure the standoff to the underside of the module with

the screw provided.

2. Align the module with the CN5 pin header and mounting

hole.

3. Insert the module onto the pin header and secure with

the screw provided from the back side of the CT-30.

4.3 RTM (cPCI-R3920T) Installation

Follow the typical cPCI board installation and removal procedures

for the RTM. However, be careful when when inserting or remov-

ing RTMs to the chassis as these are shorter than front boards.

Refer to previous sections when connecting or installing peripher-

als to the RTM. Make sure that the RTM you are installing are

compatible with the CT-30.

NOTE:

You must install the correct RTM to enable some functionalities

(I/O interfaces) on the rear panel. Installation of non-compati-

ble RTMs may damage the system board and/or other RTMs.