Installation Guide

Fill With
Concrete
Square and Secure Post using
Surface Mounts
Visually square the unit into the space where you intend to
permanently install
Measure and mark out the locaton of the posts. Diagonal
distances must be the same to ensure square installation.
Use 1/4” x 2 1/4” wedge or concrete anchors (not included) to
secure to concrete or similar sized lag screw with washer for
mounting to wood.
Please Note:
Concrete patios generally have sloped surface for water run-off.
If this is the case, when you secure the surface mount to the
concrete, the bracket may be at an angle. This can be corrected
for level using galvanized steel washers (not provided), acting
as shims underneath the base to level - VERY IMPORTANT OR
SHOWER BEAMS WILL NOT BE LEVEL.
1
2
14
STEP SEVEN
F
2
33 1/8 in
84.0 cm
35 1/8 in
89.1 cm
48 3/8 in
122.7 cm
Marker
3
OR
Square and Secure Post into the
Ground using Post Extension &
Concrete Footing
Visually square the unit into the space where you intend to
permanently install
Temporarily move the unit out of the away.
Dig 9” diameter holes, 36” deep into the ground (or below
the frost line).
Lower the entire unit into the ground and concrete
in place as illustrated. Support blocks will allow you to
level and support the posts until concrete cures.
1
2
3
4
3
Support Blocks
Rear Wall
Gate Opening
Side Wall
Side Wall
3
4