Installation Guide

1
2.
fence panel and posts and continue driving all your pipe. This will enable you to work with an unobstructed string line.
3.
4. For easier spacing of pipe anchors, you can optionally use a piece of 1x4 wood lumber cut at 70 1/4” for step 3 on page
two.
Use a wood spacing guide (not included) cut to 70 1/4” to
help identify the location of your next pipe anchor.
5
. Most yards are relatively level and will allow for a fairly simple installation.
If your yard is steeply pitched or is very uneven you may need to stair step your panels as illustrated below.
Post heights can be trimmed down as necessary.
Ground
WARNING!
If your yard has a severe slope or elevation change
greater than approximately 5” to 6” over one panel of
fence, you will not be able to install this fence. your
post will not be long enough to accomodate.
8 Newport Vinyl Picket Fence Instructions
TIPS
DO-IT-YOURSELF
FRIENDLY PRODUCTS
Zippity
Dig Bottom Rail into Higher Elevation to Minimize Gap on the Lower Side