Installation Guide

Install Post over Anchor Pipe
If your ground is dry and hard, use a claw hammer to loosen
2” or 4“ of dirt around the base of the pipe. This will allow the
vinyl post to easily insert itself into the ground in step 2 below.
Orient post correctly with tabs at top and slide the vinyl post
over the anchor pipe down into the ground.
Using a wood block (or something to protect the top of the
vinyl extrusion), pound down the post another 2” to 4”
below the ground.
Repeat for second post.
1
STEP TWO
2
3
Newport Vinyl Picket Fence Instructions
2
1
DO-IT-YOURSELF
FRIENDLY PRODUCTS
Zippity
3
Optional
Optional:
Important !
The Bottom of the Vinyl Post Must Penetrate 2 to 4”
Below the Ground to Prevent it Twisting on the Pipe.