Operating instructions
OPERATION
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at Seite 61
RASENMÄHER-ROBOTER / ROBOT LAWN MOWER ZI-RMR 2600e 61
13.7.8 Setting AREA
NOTE
This function is to increase the efficacy of the mower in a large area. It allows
you to separate a larger area into 3 small areas. The function should be used
together with SCHEDULE SETTING.
1. Select SET and enter it by pressing key
2. Select AREA and enter it by pressing key
3. To select the working area.
AREA 1 is non-optional, selects this by default
Press key or key to scroll to AREA 2 and
press key to select AREA 2 works.
“*” comes in front of AREA 2.
WARNING
If is not select working in AREA 2, it cannot be set the robot working in AREA 3.
Press key or key to scroll to AREA 3 and press key to select AREA 3 works.
“*” comes in front of AREA 3.
4. To set the memory point
A Memory point is to program the mower to leave the virtual wire. Each area should with a
Memory point, 3 Memory points maximum in one mower.
NOTE
Keep the voltage of mower more than 27V before setting the memory points.
Put mower onto virtual wire with a maximum distance of 1m from charging station,
and put the backside of mower towards to charging station.
Select START and confirm it by pressing key . Then the robot starts follow virtual
wire walking.
Press key to set Memory point in AREA 1 when mower arrives at Memory 1.
Press key to set Memory point in AREA 2 when mower arrives at Memory 2.
Press key to set Memory point in AREA 3 when mower arrives at Memory 3.
It is best to set the Memory point in the middle of two corners.
A better position of Memory point is a 3 meters length of virtual wire at the beginning or the
end of an area.
Route the wire around the passage to separate the area. The virtual wire to and from the
edge of passage is 0,8m at least. Check the setting as following picture.
A minimum distance between to and from virtual wire, which are to make a passage from
one area to another one is 50cm.
Put the robot back to charging station and wait for working.