Operating instructions

TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at Seite 50
RASENMÄHER-ROBOTER / ROBOT LAWN MOWER ZI-RMR 1500e 50
15 TROUBLE SHOOTING
BEFORE USING THE WORK FOR DISPOSAL OF DEFECTIVE START, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Possible Cause
Solution
After turn on the mower by key
and set operate pattern, but the
mower still cannot start. In
addition, the charging station is
beeping.
 The virtual wire fails to send
signals.
 The virtual wire is broken
 Check the virtual wire light
(colourless). Be sure the virtual
wire is connected to the
charging station that is motion,
and there is no loose place.
 Connect the wire with virtual
wire connectors
After turn on the mower by key
and set operate pattern, but the
mower still cannot start
 No power to plug receptacle or
main power is shut off. Bad
communication between
charging station and mower
• Check the power and check the
plug. Connect charging station
with power supplier
Mower stop working and is start
to beeping.
• Mower is lifted over 2cm from
the ground.
• Cutting height too low.
• Blade or running wheels strike
hard objects.
• The mower is trapped in lawn.
• Mower is tilted over than 30
degree from the ground
• Bump sensor is activated
• Put the mower in lever ground,
turn off the mower and restart
it.
• Adjust the cutting height to
suitable height.
• Clean the grass and make sure
it is free from hard objects.
• Clear the lawn where the
mower is trapped or restart the
mower in another place.
• Put the mower in lever ground,
turn off the mower and restart
it by enter password and choose
operate pattern
• Free bump sensors
The robot is very noisy
• Damaged cutting blades
• Cutting blade flooded by
residues(tapes, ropes, plastic
fragments, etc.)
• Replace the blade with a new
one.
• Stop the robot in safety
conditions; remove the fold
cause from the blade.
Mower does not detect the
charging station contacts
• The ground before the charging
station is not flat.
• Reset the charging station in a
flat place
Mower reached the charging
station when its contacts are
above the charging station
contacts
• Height difference between the
charging station and the lawn
surface at the entrance to the
charging station.
• Confirm the ground before the
charging station is leveled with
the charging station if
necessary fill area with dirt and
level off.
Mower drives but blade will not
mow
• On manual pattern, Mow on
remote control has be turned
off.
• Turn on the mower button
Remote control does not work
• The electricity power is low
• Change batteries
Unknown trouble
• Unknown
• Turn off all switches and restart
the mower