Operating instructions

ASSEMBLY

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at Seite 41

RASENMÄHER-ROBOTER / ROBOT LAWN MOWER ZI-RMR 1500e 41

 If a high obstacle, for example a wall or fence, borders the working area, the virtual wire

should be laid at least 35cm from the obstacle. This will prevent mower from colliding with

the obstacle and reduce body wear.

 Use the virtual to demarcate areas inside the working area by creating islands around

obstacles that can not withstand a collision, for example, flower beds and fountains. Run the

cable out to the area, route it around the area to be demarcated and then back along the

same route. If staples are used, the wire should be laid under the same staple on the return

route. When the virtual wire to and from the island are close together, the mower can drive

over the wire.

 The wires leading to the island and returning from it

should be parallel and touding. But do not cross

them! If protected obstacles are grouped closely

together demarcate them by a single. Continuous

virtual island if obstacles are dose to edge, leave

them out of the mowing area.

greater

than 35cm

max.1cm

mind.35cm