Installation Manual

4 Light Vanity with Glass Globes
INSTALLATION MANUAL
Possible Cause Corrective Action
.no si ylppus rewop erus ekaM .1.ffo si rewoP .1
.hctiws ecalper ro tseT .2.hctiws ytluaF .2
3. Faulty wire connection. 3. Check wiring.
Fuse blows or circuit breaker
trips when light is turned on.
1. Crossed wires or power wire is
grou nd in g
out.
1. Check wire connections.
Light will not turn on.
TROUBLESHOOTING:
PRODUCT MAINTENANCE:
1. To clean the outside of the xture, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the surface of the xture.
2. To clean the inside of the xture, rst disconnect power to the xture by turning o the
circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly
dampened clean cloth (use clean water, never a solvent) to wipe the interior surface of
the xture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft
cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting xture to be free from defects in materials and workmanship for a
period of ve (5) years (except bulb) from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at
the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse,
accident, modications, alterations, neglect or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the nish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not
warrant and specially disclaims any warranty, whether expressed or implied, of tness for a
particular purpose, other than the warranty contained herein. The manufacturer specically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of said
product.