Installation Instructions

WALL LEDGE
STEP 4
Hang cube.
STEP 3
Tighten screws into anchor(s) and the stud(s).
1/8"
(3mm)
Maximum load claim
9 in CUBE: HOLDS UP TO 20 lbs (9 kg)
7 in CUBE: HOLDS UP TO 15 lbs (6.8kg)
5 in CUBE: HOLDS UP TO 10 lbs (4.5 kg)
TOOLS NEEDED (Not included in product)
Pencil
Screwdriver
Level
Stud Finder
Drill
NOTE FOR STUD MOUNTING：
◆
Anchor is not necessary for stud mounting.
◆
Additional tool/hardware may be required
for stud mounting, or if on wall surfaces
other than dry wall. Consult your local
hardware store.
HARDWARE (Included in product)
plastic dry wall anchor
Size : 9mm
Ø x 32mm L
philip head screws
mounting bracket
Stud screw (6mm Ø x 30mm L)
Anchor screw (6mm Ø x 25mm L)
STEP 2
2a
Drywall mounting: Tighten the anchors into
dry wall with Philips screw driver until anchors
are flush with the wall surface.
STEP 1
1a
Drywall mounting: Choose a desired location.
Mark mounting holes for anchors.
1b
Stud mounting: Choose a desired
location. Use a stud finer and mark
the location of studs.
2b
Stud mounting: Drill pilot hole and drive
the stud screw into the pilot hole.
If cube cannot hang on to the screws, untighten the screws slightly and re-hang.
Repeat as necessary.