Installation & Assembly

ManualsBrandsZipcode Design ManualsDesksStephon Desk

Table Of Contents

Recomm. 2 Person

Approx. 30 minutes

Tool RequiredTool Required

Assembly Instruction

Multipurpose Home Office

Computer Writing Desk w/Bin

Recommended Maximum Weight

Unfold Bin (9) and slide into the shelf.

STEP 14

Attach Back Panel (M) to the back of

assembled unit using Power Pin (6).

STEP 13

(6)x12pcs

WARNING:

>This unit has been designed to support the

maximum loads shown. Exceeding these

load limits could cause sagging, instability,

product collapse, and/or serious injury.

>DO NOT allow children to climb on unit.

>Put heavier items on lower shelves.

*Unit in pound (lbs)

(9)

Summary of content (4 pages)

PAGE 1
STEP 13 STEP 14 Attach Back Panel (M) to the back of assembled unit using Power Pin (6). Unfold Bin (9) and slide into the shelf. Assembly Instruction Multipurpose Home Office Computer Writing Desk w/Bin (9) Approx. 30 minutes (6)x12pcs Recomm. 2 Person Recommended Maximum Weight 10 Tool Required 15 10 WARNING: >This unit has been designed to support the maximum loads shown. Exceeding these load limits could cause sagging, instability, product collapse, and/or serious injury.
PAGE 2
No Hardware List Qty No Parts List Qty STEP 11 Attach Panel (A) to Panel (C)&(D) and tighten Cam-Lock Nut (4) using screwdriver.
PAGE 3
STEP 9 STEP 1 Attach Panel (C) to the assembled unit using Screw (1). Insert Dowel (2) and Cam-Lock Nut (4) into the pre-drilled holes on Panel (C,D,E,F,G&H). (4)x2pcs (2)x2pcs Arrow on Cam-Lock Nut (4) should be pointing towarcls holes. 4 (1)x4pcs STEP 10 10.1 Attach Panel (G) to Panel (F) using Screw (1). 10.2 Attach Panel (F)&(G) to Panel (A) using Screw (1). STEP 2 STEP 3 Install Nail Leg (3) to the bottom of Panel (C)(D)&(H) using rubber mallet.
PAGE 4
STEP 4 STEP 6 STEP 7 Fix Drawer Slide (7) to Panel (L) using Screw (8). Note: Please make sure L&R Side of Drawer Slide (7) before attach it. Attach Panel (E) to Panel (I) using Screw (1). Attach Panel (J) to Panel (H) using Screw (1) and tighten Cam-Lock Nut (4) on Panel (H) using screwdriver. (8)x4pcs Front Side (1)x2pcs STEP 5 Fix Drawer Slide (7) to Panel (C)&(D) using Screw (8). Note: Please make sure L&R Side of Drawer Slide (7) before attach it.