Quick Start Guide

Press and hold (3 sec) the power button on top of the ZipaTile2. Boot process will start with the logo on the
screen and it will finish when you see the Zipato login screen.
4.0 | POWERING ON YOUR ZIPATILE2
5.1 | Wi-Fi
5.2 | ETHERNET
5.0 | CONNECTING TO THE INTERNET
ZipaTile2 has to be connected to the Internet, over the Wi-Fi or Ethernet, to configure it properly. The user
needs to open “Android Settings” to connect to the Internet. It is the standard menu where the user can
configure Network, Device, Personal and System settings related to the Android operating system.
Some wireless networks do not broadcast their names (SSID). In that case, select three dots in the
upper right corner and choose Add network from dropdown menu. To make the connection, type
the network name (SSID) and follow the above procedure from step 4. When setup completes, Wi-Fi
Connected icon appears.
If you have Wi-Fi network follow these steps:
If you have Ethernet connection follow these steps:
1. Open the Android Settings app.
2. Choose Wi-Fi.
3. Turn on Wi-Fi to view a list of available Wi-Fi networks.
4. Select one of the available Wi-Fi networks.
5. If prompted, type the network password.
6. Press the Connect button. The network is connected
immediately. If not, check your password and try again.
1. Plug ethernet cable into Zipatile2.
2. Plug ethernet cable into the ethernet port.
3. Wait until the icon appears on the status bar.
Android Settings
N
L
24VAC
Heat
System
120VAC
RS-485 bus
HVAC W HVAC RC HVAC Y HVAC RH HVAC O HVAC* HVAC
C
HVAC G RS-485 A RS-485
B
Cool
System
Fan
Relay
Rev.
Valve
Rev.
Valve
3.2.2 HVAC HARDWARE VARIANT
Connect only if ZipaTile2 is equipped with PoE module,
and you intend to power it from thermostat wiring.