Quick Start Guide

Table Of Contents

2.2 | INSTRUCTIONS

DRILL TEMPLATE

1. Choose your mounting location. Tape the Drill template, logo side up, in the location you want to

install your ZipaTile2. Make sure it is leveled.

2. Drill through the four marked screw hole locations with a 1/5” (6mm) bit suitable for your wall type.

3. Make sure you have enough room (or a hole in the wall) to route all the wires and cables on the back side

2.0 | MOUNTING ZIPATILE2 ON A WALL

2.1 | REQUIREMENT

• Screwdrivers: flathead and Philips

• Pliers

• Wire stripper / wire cutter

• Non-contact voltage detector

• Electrical tape

• Drill and drill bits appropriate for the wall type

NOTE Use safety goggles and gloves when drilling holes in the wall for screw anchors.

NOTE This product should not be plugged in sockets that can be turned off with a switch.

Risk of Electrical Shock Before performing any electrical work, turn OFF the power to the AC

wires leading into the in-wall box at the main power source. Before starting the installation, use a

non-contact voltage detector to ensure that there is no power to any wires in the wall box.

CAUTION! Installations should be performed in accordance with all national and local electrical codes. If

you are unsure or have questions about the installation, please seek the advice of a qualified electrician. Do

not apply power to the ZipaTile2 before completing the installation. Please make sure that a proper power

cut-off device is part of your power supply circuit (electrical fuse).

Wall mount with Built-in Power Supply

of the ZipaTile2. Use the area marked on the drill template (129x30mm) to check.

4. Remove the drilling template.

5. Insert the plastic inserts into holes in the wall. Push them 3 mm deeper into the wall, to make room for

bulges on the wall mounting bracket.

6. Place the ZipaTile2 wall holder over the holes and install it using the provided screws.

2.2.1 | WALL MOUNT WITH BUILT-IN POWER SUPPLY (recommended)

For compact wall mounting into an in-wall box, clip-on wire adapter onto the power supply and connect

the adapter wires to the AC wires.

2.2.2 | WALL MOUNT WITH PLUG-IN POWER SUPPLY

If there is no in-wall box at the desired mounting location, please use the wire channel at the back of the

device to place the power wires behind the ZipaTile2 and use the bundled plug-in power supply to connect

to a wall socket.

Wall mount with plug-in Power Supply