Installation Guide
Page 16 of 20 803341 - Tap Installation Instructions - 02.17 - v2.02
External HOT & COLD
isolation valves
(Not supplied)
Tee piece
(Supplied)
Typical All-In-One Mains Installation
5.7
Note:
Note:
All silicon tubes must be
All silicon tubes must be
cut to size. They must have a con-
cut to size. They must have a con-
stant fall back to the unit.
stant fall back to the unit.
RED Boiling
BLUE Chilled
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied
Installation Instructions