Technical data

7
Electronic instantaneous water heater MDX 3..7
If you wish to enjoy hot water at a hand wash basin and conserve
energy at the same time then the MDX is the best choice you can
make. Sophisticated electronics automatically regulate the output
power to ensure the desired temperature is not exceeded at the
point of use. That means: Turn on the tap and hot water flows at the
perfect temperature!
· Mini-sized, electronically controlled under-sink instantaneous
water heater to supply hot water to a wash basin
· Electronic power control adjusts to compensate for inlet pressure
and temperature variations
· Outlet temperature and flow rate are preset inside the appliance
(factory setting approx. 38 °C)
· Bare wire technology IES
®
achieves maximum efficiency plus the
fastest possible heat up time
· Supplied complete with special tap nozzle with integrated flow
regulator for fitting in tap threads M22 / M24 and a connection
set (T-piece and flexible pressure hose
3
/
8
“) for an angle valve
· Performance: MDX 3: 3.5 kW 230 V (approx. 2.0 l / min 38 °C)
MDX 4: 4.4 kW 230 V (approx. 2.5 l / min 38 °C)
MDX 6: 5.7 kW 230 V (approx. 3.3 l / min 38 °C)
MDX 7: 6.5 kW 400 V (approx. 3.7 l / min 38 °C)
· Dimensions (H × W × D): 13 × 18.5 × 8 cm
The clever way to heat water for handwashing
MDX 3 · MDX 4 · MDX 6 · MDX 7
Colourful and highly convenient: Smart
instantaneous water heater and a sensor tap
The new under-sink unit MDX Lumino combines conveni-
ence with energy efficiency in designer washrooms. As well
as regulating the heating element of the instantaneous
water heater the water-saving sensor tap indicates the
temperature of the water by means of a coloured LED ring.
The temperature is set using a lever on the side of the tap,
eliminating the need to add water. The water is heated in
the instantaneous water heater to precisely the ideal tem-
perature desired at the point of use. The water flows only
when the user’s hands are within the sensing range of the
infra-red detector.
SOLAR
ready