Technical data
65
Model MDX 3 MDX 4 MDX 6 MDX 7
Product code 13003 13004 13006 13007
Complete systems with touch-free sensor tap MDX 3 Lumino MDX 7 Lumino
Use
Nominal capacity litres 0.2 0.2 0.2 0.2
For one outlet • • • •
Application handwash basin /
kitchen sink
• / – • / – • / • • / •
Installation type undersink unit • • • •
Electrical data
Type closed-outlet • • • •
Maximum static pressure MPa (bar) 1 (10) 1 (10) 1 (10) 1 (10)
Water system connections (thread connection) G
3
/
8
“ G
3
/
8
“ G
3
/
8
“ G
3
/
8
“
Factory set temperature °C 38 (installer temperature adjustment between approx. 30 and 50)
Hot water flow rate at ∆t = 25 K
1)
l/min 2.0 2.5 3.3 3.7
Switch-on – maximum flow rate
2)
l/min 1.2 – 2.0 1.5 – 2.5 1.5 – 3.3 1.5 – 3.7
Nominal power rating
3)
kW 3.5 4.4 5.7 6.5
Supply voltage V 1 / N / PE ~ 230 1 / N / PE ~ 230 1 / N / PE ~ 230 2 / PE ~ 400
Nominal current A 15 19 25 2 × 16
Required cable size
3)
mm
2
1.5 2.5 4.0
4)
2.5
VDE approved, CE endorsed / Protection class • / IP 24 • / IP 24 • / IP 24 • / IP 24
Features
Control electronical • • • •
IES
®
Bare wire heating system / Ω cm
5)
• / 1300 • / 1000 • / 1000 • / 1300
Electronic control system with temperature and flow sensors
• • • •
Replaceable heating cartridge • • • •
Power cable with plug / for permanent connection • / – – / • – / • – / •
T-piece with pressure hose / Special jet regulator • / • • / • • / • • / •
Solar-compatible (Inlet temperature < 60 °C) • • • •
Dimensions and weight
Dimensions (Height × Width × Depth) cm 13 × 18.5 × 8 13 × 18.5 × 8 13 × 18.5 × 8 13 × 18.5 × 8
Approx. weight (filled with water) kg 1.5 1.5 1.5 1.5
• = included resp. yes 1) Temperature increase e.g. from 15 °C to 40 °C 2) Flow limited in order to obtain optimal temperature increase, can be adjusted inside the unit 3) Regulations vary according to the
regional power supply authority. Must be connected by a qualified electrician only. 4) Use the power supply cable supplied 5) Permissible minimum electrical resistance of the water at 15 °C
Jet regulator (tap nozzle)
All mini instantaneous water heaters
from CLAGE are supplied with an
appropriate jet regulator that opti-
mises the stream of water dispensed
in line with the performance rating of
the respective appliance, and supports
its energy and water saving mode of
operation.
To ensure optimal operation of the
heater, this jet regulator must be fitted
to the tap spout.
Jet regulator Mini instant water heater
Model M..3 / M..4 M..6 / M..7
CSP 3
CSP 6
CSM
Mini electronic instant water heaters 3 – 7 kW
Technical Data