Installation Guide

804052 - CS Residential- Installation Instructions - Sept 2016 - v3.01 Page 15 of 20
CO
2
pressure set zone: 2.7-3.0 bar
IMPORTANT:
4.3 After replacing a bottle or after mak-
ing a gas connection, check for gas leaks:
Stage1:
1. Turn the gas OFF
2. Using soapy water applied with a sponge, or with a
brush, cover all of the gas joints with a liberal
amount of suds.
Stage 2:
1. Turn ON the gas
2. Inspect the joint for leaks
3. If any bubbles appear, the joint
will need to be resealed.
e
ak
s
t
h
j
i
t
Faulty seal joint
CO
2
Connections & Leak Testing
4.4
Installation and connection
• Install the undersink unit with the connections
shown below