User Manual

Page 14 of 24 802258UK G4 Boiling (& ambient) residential, user guide - August 2015 - V2.01
• Press the [MENU] button for main
menu.
• Press the [Install] button.
• Press the [Filter Reset] button.
• Press the [Reset Internal Filter] /
[Reset External Filter] button.
• If you need to flush the filter follow
the filter flush guide, see page 13.
• To cancel the filter reset program
press [HOME] or [<=].
• To set the filter life or edit filter
usage, see page 18.
After replacing the filter, the counters should be reset.
• Press the [MENU] button for main
menu.
• Press the [Install] button.
• Press the [Boiling Calibration]
button.
• In the next screen, press
[Calibrate] if you want to start
calibration.
Boiling calibration screen
3. Boiling calibration
• Press the [MENU] button for main
menu.
• Press the [Install] button.
• Press the [Boost] button.
• In the next screen select [YES] to
enable the booster.
Dispense boiling water for 30
seconds and check the (insulated)
outlet hose from the booster is
warm.
This function should only be used when a booster unit is installed.
Booster screen
4. Booster
Note Failing to make the correct selection for [Boost] will affect product
performance.
2. Filter reset
LCD screen operation - section C
Caution In general, boiling water units may vent steam from the tap spout.
Take care to avoid personal injury whenever this occurs.
The Zip HydroTap
®
G4 is equipped with a self-calibrating program. On first
start up, the controls take the system through a calibration process. Once
this mode is completed the system reverts back to normal operation. If you
would like to calibrate the system anytime after installed, please follow the
steps below.