Installation Guide

Page 4 of 32 802257K - G4 Boiling (& ambient) residential installation instructions - Aug 2015 - V2.01

Before installation

• Read the instructions and check if there is adequate space to install all of the components.

• Note Not all fittings are supplied with the appliance kit. Isolation valves are not supplied.

• Check the mains water pressure is within min / max requirements (see page 9).

• Check the water quality to determine if extra filtration will be required.

• Note This product must be fitted to a potable water supply.

• Check the Command-Centre

rating plate and ensure correct power is available.

• Check the under counter cupboard floor supporting the Command-Centre

is adequate for its

total weight, when full of water.

Before commissioning

• Check the system has been installed correctly.

• Check all plumbing fittings have been tightened.

• Ensure the outlet and vent pipes are positioned to drain correctly.

• Ensure there is adequate ventilation.

• Check all tubes and pipes from the Command-Centre

to the tap have a constant rise and there

are no sags or kinks in the hoses.

• Check all electrical connections are correct and there are no loose wires.

Commission (see section 5)

• Flush the supply line before connecting.

• Turn on the water and check for leaks.

• Flush the filter(s).

• Activate / enable the booster (if fitted).

• Calibrate the safety sensor for boiling models.

• Where applicable, programme the Command-Centre

to suit the customer’s requirements.

Installation checklist