Installation Guide

Page 16 of 32 802257K - G4 Boiling (& ambient) residential installation instructions - Aug 2015 - V2.01
1.10
Braided
hose x 3
Mixer tap installation
1.11
Nut
Lower rubber
washer
Upper rubber washer
Washer
Nut
Lower rubber
washer
Upper rubber washer
Washer
White marking - Ambient
mains supply
Blue marking - MIXER IN
on Command-Centre
TM
Red marking - MIXER OUT
on Command-Centre
TM
Note Make sure the tap location will allow the tap
spout to drain into the sink.
Note The mixer tap requires a Restrictaow valve,
supplied, to be tted in the cold water supply line,
from the isolation valve T-piece, to the mixer tap.
• Slide upper rubber washer in place on underside
of tap.
• Mount tap in position on Ø35mm hole.
• Slide lower rubber washer, metal washer then
tap nut over thread extension, then tighten the
tap nut to secure in place, do not over tighten.
• Attach the braided hoses (ensure the seals on
the end of the hoses are lubricated), do not over
tighten.
Cut a Ø35mm hole in the work / sink top.
Ø35mm
Clearance
envelope
535mm
min. 300mm
(See page 26 and 27 for Command-Centre
TM
connections).
335mm