Installation Guide

802257UK - G4 Boiling (& ambient) residential installation instructions - Aug 2015 - V2.01 Page 11 of 32
Special tools required
In addition to normal tools, the following will be required.
For the HydroTap
®
G4 and mixer taps.
• 35mm diameter sheet metal hole punch for sink tops (not supplied).
• 35mm diameter hole saw for worktops (not supplied).
• Nut runner tube spanner (supplied) for fixing the tap assembly.
When installing a font, the following will be required
• Classic and Elite, 108mm diameter sheet metal or hole saw to suit surface being cut.
• Arc / Cube 140mm diameter sheet metal or hole saw to suit surface being cut.
Hole positioning
Position the tap such that it dispenses into the sink bowl with ample clearance for a cup or tea pot.
Alternatively, the tap could be mounted away from the sink using a Zip Font, available as an accessory
(see Major components and accessories, page 8).
Tap positioning
Section 1
Tap installation
Tap Recommended dispensing
distance (mm)
Elite 116
HydroTap
®
Classic 116
HydroTap
®
Arc/Cube 171 (174 extended)
Mixer - Arc 231
Mixer - Classic 270
Mixer - Cube 310
Boiling only HydroTap
®
G4 Classic
116
Note Mixer taps have spouts that swivel.
All images are for illustrative purposes, to aid
understanding of the system configuration,
and are not prescriptive of tap positioning.
• Ensure that the taps are mounted in
a position that allows the water to safely drain to
waste throughout the complete positional range.