Installation Guide

Page 32 of 40 801314 - Zip HydroTap BC, BCHA, AIO, Installation Instructions - Aug 2015 - V2.01
Installation Instructions
Note: to activate the filter, flush at least 10L of water through the filter before connecting to a softener or to a
Booster heater.
: Not required for AIO mains pressure HydroTap.
External HOT and COLD
isolation valves (Not Supplied)
Tee piece
(Supplied)
Booster
RED
CLEAR
BLUE
BRAIDED
5.5 Model All-In-One Mains Pressure
Booster option
POWER
CORD
USB
CHILLED
OUTLET
MAINS
IN
MIXER
OUT
MIXER
IN
BOILING
OUT
BYPASS
IN
VENT
BYPASS
OUT
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied
Note: All
silicon tubes
must be cut to
size. They must
have a constant
fall back to the
unit.
Note: The tube lengths are matched to the pumps performance and therefore CANNOT be lengthened