Installation Guide

801314 - Zip HydroTap BC, BCHA, AIO, Installation Instructions - Aug 2015 - V2.01 Page 17 of 40
1.12 Installing the Mixer Tap (Classic, Arc and Cube)
Installation Instructions
• Fit the O-ring into the recess on the underside of the Mixer tap. (Note: If mounting on an uneven
surface, a light smear of silicone on the O-ring will ensure a water tight seal)
• Pass the tap tubes and threaded extension through the 35mm hole and position the tap so that it
discharges into the sink.
• Fit the lower rubber seal to the threaded extension.
• Secure the tap in position with the metal washer and Nut.
• Affix the three hoses to the tap. Match the hose colours to the coloured bands on the copper extension
tubes. (See diag. 1.11)
Sink top
O-ring
Lower seal
Washer
Securing nut
Mixer tap
Arc Mixer Tap