Product Sheet

A. Location
Tap must be positioned so that it drains into a
suitable sink, or be installed on the optional tap
“font kit” which is plumbed to waste. Tap should
be situated as closely as possible to directly above
the under-sink G4 Command-Centre. Maximum
distance from the base of the tap to the G4
Command-Centre is one metre (may be extended
if required). G4 Command-Centre must have
clearances as shown on the drawings. Ventilation
accessories (supplied) must be installed as per
instructions.
B. Plumbing
Must be installed in accordance with
AS/NZS3500 plumbing regulations. Designed
for direct connection to a potable (drinkable)
cold water supply with minimum pressure of 172
kPa. A 500 kPa pressure limiting valve and dual
check valve are fitted internally to comply with
AS/NZ3500. An isolating valve should be fixed
between the water supply and the under-bench
G4 Command-Centre.
C. Electrical
Designed to be connected to a 10 amp GPO,
240-230 volt AC power supply in accordance
with AS/NZS3000 wiring regulations.
D. Carbon Dioxide
The CO
2
gas cylinder (supplied) must be secured
in a suitable location using the strap provided.
The gas regulator (supplied) must be fitted.
Each cylinder contains 1 kg of CO
2
and should
be installed in a well ventilated area or a room of
not less than 38 cubic metres. See website for
gas cylinder MSDS sheet giving a complete list of
CO
2
warnings.
Warranty
Five year warranty.
Appliance warranty 36 months
plus additional 24 months tank
warranty. See website for details.
Accessories
90915 – Zip font installation kit
91290 – Zip 0.2 micron replacement filter
91295 – Zip CO
2
cylinder twin pack
Standard tap finish: bright chrome.
Brushed chrome or black also available.
Call Zip for details and a quotation.
Accessibility
To order any model to be supplied with extension
levers and Braille pads, add D to the end of the
order code.
Technical Assistance
Zip Heaters (Aust) Pty Ltd
67-77 Allingham Street
Condell Park NSW 2200
Free Call 1800 638 622
www.zipindustries.com
As Zip policy is one of continuous product
improvement, changes to specifications may
be made without prior notice. The terms ‘Zip’,
‘HydroTap’, ‘Power-Pulse’, ‘Free-Flow’ and ‘G4
Command-Centre’ are trade marks.
100
ø 35 mm hole required if the G4 Tap is fitted to sink
50 min.
280
50 min.
Inlet Vent
ø
CO 2 Cylinder
1.0 Kg
104
399
Mains cold water
isolation valve
(not supplied)
Clearance
Envelope
Residential Specification Sheet | Z0767 June 2014
Order Code Zip Model Rating (kW) @ 230 V Cabinet Dimensions W x D x H (mm)
HT1787 Zip HydroTap G4 CS 0.3 280 x 389 x 333
Order code shown here is for the model installed at a sink. To install on a “font” also specify a font kit: order code 90915.
Zip HydroTap
®
G4 CS
Chilled | Sparkling | Filtered | Instantly