Installation Guide

802253 - HydroTap BC, BCHA -AV, AIO, Installation Instructions - June 2015 - V2.01 Page 31 of 36
Note: to activate the filter, flush at least 10L of water through the filter before connecting to a softener or to a
Booster heater.
Installation Instructions
4.5 Model: All-In-One Vented
Tee piece and
Restrictafl ow
valve (supplied)
External COLD
isolation valve
(Not Supplied)
RED
CLEAR
BLUE
BRAIDED
POWER
CORD
USBMAINS
IN
MIXER
OUT
MIXER
IN
BOILING
OUT
BYPASS
IN
VENT
BYPASS
OUT
CHILLED
OUT
Booster
HT Mixer
connections
BRAIDED BRAIDED BRAIDED BRAIDED
Note: All
silicon tubes
must be cut to
size. They must
have a constant
fall back to the
unit.
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied
Note: The tube lengths are matched to the pumps performance and therefore CANNOT be lengthened