Installation Guide

Page 34 of 44 801910 - Zip Sparkling HydroTap - Installation Instructions - July 2015 - v2.01
Installation Instructions
Note: to activate the filter, flush at least 10L of water through the filter before connecting to a softener or to a
Booster heater.
: Not required for AIO mains pressure HydroTap.
Note: The tube lengths are matched to the pumps performance and therefore CANNOT be lengthened
External HOT and COLD
isolation valves
(Not Supplied)
Tee piece
(Supplied)
6.5 Model All-In-One Mains Pressure - BCSHA 160/175
RED
CLEAR
BRAIDED
GAS IN
POWER
CORD
USB
CHILLED
OUTLET
MAINS
IN
MIXER
OUT
MIXER
IN
BOILING
OUT
BYPASS
IN
VENT BYPASS
OUT
SPARKLING
OUTLET
CO2
IN
BLUE
WHITE
Note: All
silicon tubes
must be cut to
size. They must
have a constant
fall back to the
unit.
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied