Installation Guide

801910 - Zip Sparkling HydroTap - Installation Instructions - July 2015 - V2.01 Page 21 of 44
Installation Instructions
1.20
Typical All-In-One Vented assembly with Booster heater
Booster
BCSHA Unit
A-I-O Tap
400mm
335 mm
Restrictaflow valve & Tee piece
(Supplied)
Note: The All-In-One vented taps require a Zip Restrictafl ow valve and Tee piece, as supplied, to be fi tted in
the cold water supply line, from the isolation valve (Not supplied), to the mixer tap. (See diagrams)
Note: All plastic tubes must be cut to size. They must have a constant fall back to the unit.
Note: Fit the insulation (supplied) to the JG tubes used for Boiling and for Chilled water
Note: All
silicon tubes must
be cut to size. They
must have a con-
stant fall back to the
unit.
Note:
- Mains hose
length is 750mm
- Plug and Cord
length is 1800mm
Position the under
sink unit close
to the outlet tap,
within reach of
the hose and cord
lengths supplied